Sidebar
Menu
Stacks Image 108
Map Editing
Many of the calibration maps are 3D. This section explains how 3D maps can be edited.

Active Cell and Cursor
There are two highlighted points. Green is used to indicate the current engine speed and load point that the motor is operating at. This is the active cell. The selected cell has a thick black border and shows where changes will be made.

Pasted Graphic


Navigation
The four arrow keys move the cursor along the axes when either the map or the map data windows are selected. The arrow keys will behave as expected based on the window that is selected.

Tracking
Tracking mode is an alternative navigation mode in which the selected cell always follows the active cell automatically. This is useful in cases where you wish to make changes only at the current active cell without having to constantly chase the active cell with the arrow keys. To use tracking mode, right-click on the 3D Grid Map and select “Tracking”, or use the hotkey F8.

Note: The arrow keys cannot be used to move the cursor while in tracking mode.


Editing
Editing the 3D Grid Map is simple. To edit a value, double-click on the value you would like to edit. Then type the desired value. To save the value, press Enter.

Arithmetic Functions
The four basic arithmetic functions can be used to adjust any selected cell(s) in the 3D Grid Map. This function also works with multiple cells. To select multiple cells, click and drag the cells you wish to select.
To add a value to a cell, press the “A” key or right-click on the cell you wish to edit and select “Add”

Pasted Graphic

Press the S key to directly enter a value to subtract from the current cell:

Pasted Graphic

Press the M key to directly enter a value by which to multiply the current cell:

Pasted Graphic

Press the D key to directly enter a value by which to divide the current cell:

Pasted Graphic

Note: The V key is no longer used as a shortcut to divide.


Select All
The Edit→Select All menu item or Ctrl+A can be used to select all of the cells in a map:

Pasted Graphic


Interpolation
To interpolate a region of cells, select a block of multiple cells to perform interpolation across, then right-click on the selected cells and select either “Interpolate Rows” or “Interpolate Columns” depending on the situation. The “X” key will Interpolate Rows and the “Y” key will Interpolate Columns.


Clear Traces
As the track point moves, it leaves a trace of bolded values to indicate which cells of the map have been used:

Pasted Graphic

This trace can be reset by selecting Tools→Clear Visited Cells

Pasted Graphic

When editing changes are made to cells, the cell values are highlighted in red:

Pasted Graphic

Note: Red edit traces cannot be cleared unless the map is saved and uploaded to the unit.